Chromabender x-reed setup question (PC tuning)
Posted: Mon Sep 18, 2017 1:52 pm
I just recently setup a C chromabender to PC CEbGBb/DFAC.
For the x-reed, I tuned holes 1 to 3 down to a point where I can get a full step out of the bend.
I am a bit confused the 4th x reed. I am assuming it's is for the draw interaction. I dropped it a bit also; however on 4 blow, (depending how I hit the note) it will sometimes resonate another note that I think is coming from the x-reed tone range. It does not appear to happen further up the harp, but I have yet to tune the next two octaves.
Are there any special considerations I should take when setting up a chromabender for PC tuning such as this? Perhaps I missed something that is causing the issue. Also, would there be any issues I need to look out for with tuning the higher octaves?
For the x-reed, I tuned holes 1 to 3 down to a point where I can get a full step out of the bend.
I am a bit confused the 4th x reed. I am assuming it's is for the draw interaction. I dropped it a bit also; however on 4 blow, (depending how I hit the note) it will sometimes resonate another note that I think is coming from the x-reed tone range. It does not appear to happen further up the harp, but I have yet to tune the next two octaves.
Are there any special considerations I should take when setting up a chromabender for PC tuning such as this? Perhaps I missed something that is causing the issue. Also, would there be any issues I need to look out for with tuning the higher octaves?