Custom made reedplates? Standard reed width?
Posted: Mon Jul 16, 2018 11:18 pm
Hi,
First post to this forum.
Does anyone here make (or use) custom made reed plates? My understanding is that manufacturers punch them out of sheet brass. But I'm wondering how hobbyists/inventors (such as Brendan) make theirs?
And that brings up the related question, if i am going to make my own plates, what is a good slot width to use. Or from another angle, who is a good source of quality reeds, and what is their standard width.
For example, should i expect that all Hohner harmonicas have the same width of reeds? Are Hohner reeds easily available?
Any info or advice appreciated!
First post to this forum.
Does anyone here make (or use) custom made reed plates? My understanding is that manufacturers punch them out of sheet brass. But I'm wondering how hobbyists/inventors (such as Brendan) make theirs?
And that brings up the related question, if i am going to make my own plates, what is a good slot width to use. Or from another angle, who is a good source of quality reeds, and what is their standard width.
For example, should i expect that all Hohner harmonicas have the same width of reeds? Are Hohner reeds easily available?
Any info or advice appreciated!