Chromabender x-reed setup question (PC tuning)

A space for players interested in my specialist harmonicas, alternate tunings, instructional material, recordings etc to ask questions and share information, experiences, videos etc.
Post Reply
Sachlaw
Posts: 12
Joined: Fri Mar 24, 2017 11:30 pm

Chromabender x-reed setup question (PC tuning)

Post by Sachlaw » Mon Sep 18, 2017 1:52 pm

I just recently setup a C chromabender to PC CEbGBb/DFAC.
For the x-reed, I tuned holes 1 to 3 down to a point where I can get a full step out of the bend.
I am a bit confused the 4th x reed. I am assuming it's is for the draw interaction. I dropped it a bit also; however on 4 blow, (depending how I hit the note) it will sometimes resonate another note that I think is coming from the x-reed tone range. It does not appear to happen further up the harp, but I have yet to tune the next two octaves.

Are there any special considerations I should take when setting up a chromabender for PC tuning such as this? Perhaps I missed something that is causing the issue. Also, would there be any issues I need to look out for with tuning the higher octaves?

User avatar
Brendan
Posts: 202
Joined: Fri Mar 24, 2017 2:28 pm
Contact:

Re: Chromabender x-reed setup question (PC tuning)

Post by Brendan » Thu Sep 21, 2017 5:43 am

The ChromaBender reedplates are designed for Solo tuning. To adapt for PowerChromatic you need to reverse the reed direction of the X-Reed in holes 4/8/12 to match the other X-Reeds. Remove the reed and reinsert on the other side of the reedplate, then retune to the desired pitch.

Post Reply