Installing powercomb on 260

A space for players interested in my specialist harmonicas, alternate tunings, instructional material, recordings etc to ask questions and share information, experiences, videos etc.
User avatar
PBaughman
Posts: 8
Joined: Fri Aug 03, 2018 6:45 pm

Re: Installing powercomb on 260

Post by PBaughman » Sat Aug 11, 2018 3:15 am

I don't understand why these nails are to be put back in - instead of screws. Why install any screws at all?

If I knew what size screws to get I could search for them on line.

now I need new valves cause I creased a few trying to get the broken spring out.

User avatar
PBaughman
Posts: 8
Joined: Fri Aug 03, 2018 6:45 pm

Re: Installing powercomb on 260

Post by PBaughman » Sat Aug 11, 2018 7:43 am

I got the holes drilled ok. The comb is installed, sort of. I don't have anything to sand them down flush. I tried adjusting them before tightening but it didn't do a lot.

Image

I'll have to go intown tomorrow and get something to sand this down.

Post Reply